Bộ chuyển đổi 16 kênh E1 sang 4 Ethernet EOP Humanity HM-C1600
Humanity HM-C1600 16E1 to 4Ethernet converter realizes Ethernet transmission over 1~16E1. This model complies with GFP, VCAT, LCAS and able to work with third party device followed same protocol.
- Realizes Ethernet transmission over 1-16E1
- Comply with ITU-T G.7041, G.7042, G.7043, G.8040. It’s able to work with third party device followed same standard ITU protocol.
- Support auto delete the fault E1 channels. Auto in use after E1 is normal.
- E1 can not connect according to serial number. In case one E1 failure, the other E1 can still work.
- For 16E1 channels, the maximum tolerable time delay difference between any two can be up to 220ms.
Impedance: unbalanced 75Ω or balanced 120Ω
DB37/BNC adaptor offered for 75Ω
DB37/RJ45 adaptor offered for 120Ω
Line code: HDB3
Comply with ITU-T G.703 standard
Jitter comply with ITU-T G.823 standard
|Ethernet||4xEthernet with VLAN
Comply with IEEE802.3, IEEE802.1Q
Auto adapt 10/100M, full/half duplex
Support flow control
MAC address table capability: 1024
MAC address table aging time: 5 minutes
Minimum frame length: 64bytes
Maximum frame length: 1916bytes
E1: ALR, L01-L16, LOS,AIS,LOOP,LOF
* ALR is general alarm
* L01-L16 is for alarm E1 channel *LOS, AIS, LOOP,LOF alarm is controlled by
DIP1-2, displayed by L01-L04.
|DIP switch||DIP1,2: set alarm contents for L01-L16
DIP3: set E1 loop
DIP4: set VLAN
|Button||Local/remote alarm choice
|Management||Default with console management
SNMP option, please state when in order
|Power||AC and DC power
Less than 10W
|Environment||Working temperature: -5 ~ 50℃
Relative humidity: ≤95%, non-condensing
|HM-C1600||16E1 to 4Ethernet converter, console management|
|HM-C1600S||16E1 to 4Ethernet converter, console and SNMP management|
|HM-C1600C||16E1 to 4Ethernet converter card for HM-C616KB chassis|
|HM-C616KB||6.5U, 19inch chassis. 16slots for converter cards, 1slot for management card|