Card PCI 2 cổng CAN ICP DAS PISO-CAN200U-D CR

Thương hiệu: ICP DAS Loại: Card PCI

Tình trạng: Còn hàng

Mã sản phẩm: PISO-CAN200U-D

CAM KẾT CỦA CHÚNG TÔI

Cam kết 100% chính hãng
Hoàn tiền 111% nếu hàng giả
Giao hàng nhanh chóng & an toàn
Hàng hóa đầy đủ CO, CQ
Hỗ trợ 24/7

Để được hỗ trợ. Hãy gọi: 0904251826

Khuyến mãi đặc biệt !!!

Áp dụng Phiếu quà tặng/ Mã giảm giá theo ngành hàng.
Miễn phí vận chuyển với đơn hàng từ 10.000.000đ

FREESHIP Miễn phí vận chuyển

HSD: Không thời hạn

Sao chép

Mô tả sản phẩm

Card PCI 2 cổng CAN ICP DAS PISO-CAN200U-D CR

Features

Two independent CAN bus 2.0A/2.0B communication ports
Compatible with CAN specification 2.0 parts A and B
On-board optical isolation protection
Programmable transfer rate up to 1 Mbps
2500 Vrms photo couple isolation on the CAN bus
Jumper select 120Ω terminal resistor for each port
Direct memory mapping to the CAN controllers
33MHz 32bit 5V PCI bus (V2.1) plug and play
Universal PCI card, supports both 5V and 3.3V PCI bus
We have verified to drive 100 CAN nodes at the same time

Introduction

The CAN (Controller Area Network) is a serial communication protocol, and efficiently supports distributed real-time control with a very high level of security. It is an especially suit for networking "intelligent" devices as well as sensors and actuators within a system or sub-system. In CAN networks, there is no addressing of subscribers or stations in the conventional sense, but instead prioritized messages are transmitted. As standalone CAN controller, PISO-CAN200U-D can represents an economic solution of an active CAN board. It has two or four independent CAN bus communication ports with 9-pin D-sub connector, and has the ability to cover a wide range of CAN applications. Besides, PISO-CAN200U-D uses the new CAN controller Phillips SJA1000T and transceiver 82C250/251, which provide bus arbitration, error detection with auto correction and re-transmission function. It can be installed in a 5V PCI slot and supported truly “Plug & play”.

Specifications

Software
Driver	Windows XP/7/8/10 (32-bit/64-bit OS), Linux 2.6.x ~ 4.8.0, LabView, DASYLab, InduSoft
Library	VB 6.0, VC++ 6.0, BCB 6.0, Delphi 4.0, C#.Net, VB.Net

PC Bus
Type	Universal PCI, 3.3 V and 5 V, 33 MHz, 32-bit, plug and play

CAN
Controller	NXP SJA1000T with 16 MHz clock
Transceiver	NXP 82C250
Ports	2
Baud Rate	10 k ~ 1 M bps
Isolation	3000 VDC for DC-to-DC, 2500 Vrms for photo-couple
Terminal Resistor	Jumper for 120 Ω terminal resistor